Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic safety inspection. Road test vehicle.
REPLACE THE LEFT INNER BRAKE LIGHT BULB
THE FRONT TIRES ARE WEARING ON THE INNER EDGES POSSIBLY DUE TO SOFT CONTROL ARM BUSHINGS. THE LEFT TIRE IS NEWER THAN THE RIGHT THE REAR TIRES ARE AT THE WEAR BARS
Randy G. gave our service a 5 star review on 5/29/2020
RECOMMENDED FRONT 32 REAR38 PRESSURE IN LF32 RF31 LR 31 RR32 PRESSURE OUT LF32 RF32 LR38 RR38
Service air conditioner. Check condition of all lines for damage and leaks. Check the compressor (when accessible) for damage, missing hardware or leaks. Verify the compressor is not seized or locked up. Check service ports for missing caps, damaged threads and conformance with labeling. Inspect the condenser coil for damage, restrictions or leaks. Inspect the expansion device (if accessible) for physical damage or leaks. Inspect the accumulator receiver drier and in-line filter for damage, loose or missing hardware or leaks. Inspect the drive belts and pulleys. Inspect the fan clutch for leakage, bearing wear and proper operation. Inspect the cooling fan for bent or missing blades. Inspect accessible electrical connections for loose, burnt, broken or corroded parts. Pressure test the system at a minimum of 50 PSi. Verify the operation of the compressor clutch, blower motor and air control doors for proper operation. The high and low side operation pressures are as follows: High Low . The temperature from the center vent upon completion is .
Emilie M. gave our service a 5 star review on 5/23/2020
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic safety inspection. Road test vehicle.
REAR BRAKE PADS AT 9% – LOOK NEW. CODE IN DME : 128A02 O2 SENSOR 2 BEFORE S1 SLOW RESPONSE VALVE COVER JUST STARTING TO SEEP BELT TENSIONER STARTING TO WALK OFF ROLLER. BOTH BRAKE SENSORS TIE STRAPPED TO CALIPER ?
RECOMMENDED FRONT 32 REAR35 PRESSURE IN LF RF LR RR PRESSURE OUT LF RF LR RIGHT REAR TIRE HAS SCREW IN IT.
Brad J. gave our service a 5 star review on 5/22/2020
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
CHECK FOR SERVICE DUE
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic safety inspection. Road test vehicle.
RECOMMENDED FRONT 32 REAR35 PRESSURE IN LF35 RF36 LR 32 RR41 PRESSURE OUT LF32 RF 32 LR35 RR35
Scanned DME and found codes as follows: 130308 VANOS,EXHAUST COLD START NOT CONTROLLABLE 131408 VANOS EXHAUST CONTROL FAULT,POSITION NOT REACHED 130304 VANOS EXHAUST – CAMSHAFT JAMMED 130108 VANOS INTAKE CONTROL FAULT-POSITION NOT REACHED 120408 CHARGE PRESSURE CONTROL SWITCH OFF AS CONSEQUENCE
Krista P. gave our service a 5 star review on 5/21/2020
Scanned DME and found codes as follows: 2C90 – Bank 2, Sensor 1 Heater Activation 2CA7 – Bank 2, Sensor 1 Heater, Function 2A82 – Vanos Intake 2DEB – Power Management, Vehicle electrical system monitoring Recommend replacing the Bank 2 Forward Oxygen Sensor. After replacing the Oxygen Sensors and clearing the codes the check engine light came back on with an Engine time out code. Clear code and test drive. The readiness monitors are starting to set and the Check Engine Light is out at this time.
The tires are at the wear bars
Alycia E. gave our service a 5 star review on 5/1/2020